Panasonic WV-SP105

23
Before starting the connection, turn off the power of this camera and the devices to be connected.
Check and prepare the required devices and cables for connection.
Connection
12V IN
INITIAL
SET
ACT
LINK POWER
10BASE-T/ 100BASE-TX
LAN cable
(This illustration
represents WV-SP105.)
12V IN
INITIAL
SET
ACT
LINK POWER
10BASE-T/ 100BASE-TX
(This illustration
represents WV-SP105.)
To 12 V DC
power supply
(12 V DC)
(GND)
12 V DC power
cord plug
(accessory)
z Connect a LAN cable (category 5 or better) to the
network connector on the rear of the camera.
x Connect the power cord.
Important:
 • The12VDCpowersupplyshallbeinsulatedfromthecommercialACpower.
●
When using 12 V DC power supply*
q Loosen the screw of the power cord plug (accessory).
w Connect thecableofthe12 VDCpowersupply*tothe
power cord plug.
Strip 3 mm - 7 mm {1/8" to 9/32"} from the end of the
wire, and twist the stripped part of the wire sufficiently to
avoid short circuit.
Specification of cable (wire): 16 AWG - 28 AWG,
Single core, twisted
 • Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cord plug (accessory).
r Connect the power cord plug (accessory) to the 12 V DC
power supply terminal on the rear of the camera.
 * FOR UL LISED MODEL(S), ONLY CONNECT 12 V DC
CLASS 2 POWER SUPPLY.
Caution:
 • FORULLISTEDMODEL(S),ONLYCONNECT12VDCCLASS2POWERSUPPLY.