Attach the angle adjustment cover to the camera
Important:
• Angleadjustmentcover(accessory) is intended for the tentative adjustment of angular field of
view. Perform the final adjustment while viewing the images actually on a monitor.
• Theangleadjustmentcoverisdedicatedtothisproduct.
z Build up the angle adjustment cover (accessory).
q Insert the protrusions into the slots.
w Fold the target sections inward.
e Fold the opening sections outward
at a right angle.
x Attach the cover to the camera.
When attaching the angle adjustment cover to the camera, use a vacant tripod screw hole to
prevent the cover from dropping and to determine the position to check the angular field of
view. Place the sticker (accessory) over the tripod screw hole after checking the angular field of
view.
To Next Page
Loading...
