Panasonic WV-SP305

14
Precautions for Installation
This camera is designed to be used
indoors.
This camera is not operable outdoors.
Do not expose this camera to direct sunlight for
hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion. Keep this camera away from water and
moisture.
Installation place
Do not place the unit in the following places:
 • Locations where it may get wet from rain
or water splash
 • Locationswhereachemicalagentisused
such as a swimming pool
 • Locationssubjecttohumidity,dust,steam
and oil smoke
 • Locations inaspecificenvironment where
a solvent or a flammable atmosphere
exists
 • Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
 • Locations where corrosive gas is pro-
duced, Locations where it may be dam-
aged by briny air such as seashores
 • Locations where the temperature is not
within –10 °C to +50 °C {14 °F to 122 °F}.
 • Locations subjecttovibrations(Thisprod-
uct is not designed for on-vehicle use.)
 • Locations subject to condensation as the
result of severe changes in temperature
Be sure to remove this product if it is not
in use.
Shielded (STP) LAN cables must be used
with this unit to ensure compliance with
EMC standards. *
* PAL models only
Before installation
 • The camera mount bracket described on
page 23 shall be used to mount the cam-
era.
 • When this camera and camera mount
bracket are mounted on a ceiling or a wall,
use the screws described on page 23. The
screws to be used are not provided.
Prepare the screws according to the mate-
rial, structure, strength and other factors of
the mounting area and the total weight of
objects to be mounted.
 • Ensure that the mounting surface, anchor
and screws are sufficiently strong.
 • Do not mount this product on a plaster
board or a wooden section because they
are too weak. If this product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
Screw tightening
 • The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
 • Do not use an impact driver. Use of an
impact driver may damage the screws or
cause tightening excessively.
 • When a screw is tightened, make the
screw at a right angle to the surface. After
tightening the screws or bolts, perform
visual check to ensure tightening is enough
and there is no backlash.
Fall prevention measures
When the external safety wire is connected,
select a connection point resulting in that noth-
ing will hit people after the mount bracket is
damaged. The wire length shall be adjusted to
remove slack.