Panasonic WV-SP305

16
Major operating controls
<Side view>
<Rear view>
About the [INITIAL SET] button
After turning off the power of the camera, turn on the power of the camera while holding down this
button, and wait for around 5 seconds or more without releasing this button. Wait around 2 minutes
after releasing the button. The camera will start up and the settings including the network settings
will be initialized. Before initializing the settings, it is recommended to write down the settings in
advance.
W
ABF
SDCARD LOCK
W
Lens (option)
ALC lens connector
Tripod mount base
Auto back focus button
Slide cover
Clamp for SDHC/SD memory card
SP306
F.A.
SDCARD LOCK
Focus assist button
SP305 SP302
POWER
10BASE T/100BASE-TX
AUDIO OUT MIC/LINE IN
EXT I/O
SD CARD/FOCUS ASSIST(F.A.)
MONITOR OUT
ACT LINK
12V = IN
GND 4 3 2 1
INITIAL
SET
ALARM IN
AUX OUT
ALARM OUT
POWER
10BASE T/100BASE-TX
AUDIO OUT MIC/LINE IN
EXT I/O
SD CARD/ABF
MONITOR OUT
ACT LINK
12V = IN
GND 4 3 2 1
INITIAL
SET
ALARM IN / DAY/NIGHT IN
AUX OUT
ALARM OUT
12 V DC power supply terminal
Monitor for adjustment
Output connector
Power indicator
Access indicator
(blinking at accessing)
Link indicator (lighting at linking)
Network connector
Audio output connector
EXT I/O terminals
INITIAL SET button
Microphone/line input connector
SDHC/SD memory card error indicator/
ABF indicator (Blinks when ABF is being
activated)
SP305 SP302
SDHC/SD memory card error indicator/
F.A. indicator
(Lights when the focus assist function
is activated or when the focus ring is
positioned near the best focus position.)
SP306