Panasonic WV-SP305

20
Insert/remove an SDHC/SD memory card
Important:
 • BeforeinsertinganSDHC/SDmemorycard,turnoffthepowerofthecamerafirst.
 • WheninsertinganSDHC/SDmemorycard,makesurethedirection.
 • BeforeremovingtheSDHC/SDmemorycard,select"Notuse"for"AboutSDmemorycard"on
the [SD memory card] tab of "Basic" on the setup menu first. Turn off the power after "Not use"
selection, and then unload the SDHC/SD memory card. When the SDHC/SD memory card is
inserted or removed with the power on, data in the SDHC/SD memory card may be damaged.
(☞ Operating Instructions)
z Open the slide cover on the side of the camera, and then insert an SDHC/SD memory card into
the SDHC/SD memory card slot.
x If necessary, loosen the screw of the clamp for SDHC/SD memory card and tighten the screw
after rotating the clamp 90° clockwise.
(Recommended tightening torque: 0.19 N·m {0.14 lbf·ft})
c Close the slide cover on the side of the camera.
v To remove the SDHC/SD memory card, rotate the clamp for SDHC/SD memory card 90
degrees counterclockwise, push the memory card to unlock it, and remove the memory card
from the SDHC/SD memory card slot.
ABF
SDCARD LOCK
ABF
SDCARD LOCK
ABF
SDCARD LOCK
T
W
T
W
T
W
Label face downward
Screw of the clamp for
SDHC/SD memory card
ABF
SDCARD LOCK
ABF
SDCARD LOCK
ABF
SDCARD LOCK
ABF
SDCARD LOCK
T
W
T
W
T
W
Label face downward
Screw of the clamp for
SDHC/SD memory card
ABF
SDCARD LOCK
(This illustration
represents WV-SP306.)