11.10 Adjust the angular field of view using the extra
optical zoom function (SW355, SW352, SF335,
SW314, SP305)
Click the [Setup>>] button of “Extra optical zoom” on the [Image quality] tab of the “Image/Audio” page.
(®page 92)
It is possible to adjust the angular field of view using the extra optical zoom function.
•
: Click this button to adjust the zoom ratio to the “Wide” side in x0.1 increments until x1.0.
•
: Click this button to set the zoom ratio to x1.0.
•
: Click this button to adjust the zoom ratio to the “Tele” side in x0.1 increments until x2.0.
IMPORTANT
• The extra optical zoom function may not be activated on the appropriate position if the setting for the
function is performed after the settings for the mask areas (®page 117), privacy zone (®page 126),
VMD area (®page 141). To prevent this, perform the setting for the extra optical zoom function before
other settings.
124 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
