23
Caution:
• FOR UL LISTED MODEL(S), ONLY CONNECT PoE 48 V CLASS 2 POWER SUPPLY (UL
1310/CSA 223) or LIMITED POWER SOURCE (IEC/EN/UL/CSA 60950-1).
Before starting the connection, turn off the power of the devices to be connected.
Check and prepare the required devices and cables for connection.
Note:
• Refer to pages 26 and 27 when using the mount bracket (accessory).
• Refer to pages 26 and 27 when using the conduit.
Connect a LAN cable (category 5 or better, straight) between a PoE device (such as a hub) and the
network connector of the camera.
Connect a LAN cable (category 5 or better, straight, STP) between a PoE device (such as a hub)
and the network connector of the camera.
IMPORTANT:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m {328 feet}.
• Make sure that the PoE device in use is compliant with IEEE802.3af standard.
• When the LAN cable is disconnected once, reconnect the cable after about 2 seconds. When
the cable is quickly reconnected, the power may not be supplied from the PoE device.
Connection
Network cable
RJ-45 (female)
To Next Page
Loading...
