31
Attach the enclosure to the camera by using the tamperproof screw bit (accessory) to tighten
the 3 enclosure fixing screws (M3). (Recommended tightening torque: 0.8 N·m {8.0 kgf·cm})
Remove the cover film completely.
IMPORTANT:
• When attaching the enclosure the focus may be slightly disturbed. If this occurs, remove the
enclosure and make the necessary adjustments.
• Before attaching the enclosure, make sure that the subject is present.
• Securely tighten all the fixing screws (x3) of enclosure. Otherwise, water exposure may cause
damage or malfunction of camera, or camera dropping may result in injury.
(Recommended tightening torque: 0.8 N·m {0.59 lbf·ft})
• Remove the cover film from the dome cover.
Attaching the enclosure
Enclosure
fixing screws
Screw cover
Enclosure fixing screws
O
Ceiling
O
Wall
To Next Page
Loading...
