• [Audio bit rate] is unavailable when “G.711” is selected for “Audio encoding format”.
[Mic input volume (Camera to PC)]
Select a volume level on the PC to hear audio transmitted from the camera.
• Mic High: The volume level will become high. This setting will be applied when audio is input to the camera
using a microphone.
• Mic Middle: The volume level will become middle. This setting will be applied when audio is input to the
camera using a microphone.
• Mic Low: The volume level will become low. This setting will be applied when audio is input to the camera
using a microphone.
• Default: Mic Middle
Note
• These settings are linked with the volume settings of “Audio recording” and “Audio detection”.
[Mic input interval (Camera to PC)]
Select an interval for audio reception from the following.
20ms/ 40ms/ 80ms/ 160ms
• Default: 40ms
Note
• When a shorter interval is selected, the delay time will be shorter. When a longer interval is selected,
audio interruption may be diminished even though the delay time will be longer. Select the interval
according to the network environment.
[Permission level of audio trans./recep.]
Select an access level for audio transmission/reception from the following.
1. Level 1 only/ 2. Level 2 or higher/ 3. All users
• Default: 3. All users
Note
• Refer to page 126 for further information about the access level.
Operating Instructions 103
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
