3. Adjust the “Mic input volume (Camera to PC)” on the [Audio] tab of the “Image/Audio” page as necessary.
(®Page 102)
→ The settings and the actual audio detection status are displayed on the bottom of the preview screen.
If the volume level goes above the audio detection level, a red bar, which indicates that sound has
been detected, is displayed.
If further adjustments are required, repeat from step 2.
Note
• “Audio detection” can only be used when “Mic input” is selected for “Audio mode” on the [Audio] tab of
the “Image/Audio” page. (®page 102)
• Noise or other unwanted sound from the surrounding area may be mistakenly detected.
• Only the volume of the sound determines whether sound is detected or not, the type of sound does
not matter.
13.6 Configuration of the settings relating to the
E-mail notification [Notification]
Click the [Notification] tab on the “Alarm” page. (®page 40, page 42)
The settings relating to the alarm E-mail can be configured. It is necessary to configure the settings of the
E-mail server to perform the E-mail notification. (®page 131)
E-mail notification
[E-mail server >>]
When “E-mail server >>” is clicked, the [E-mail] tab of the “Server” page will be displayed. (®page 131)
Operating Instructions 115
13 Configure the alarm settings [Alarm]
To Next Page
Loading...
