configured in the “E-mail notification” section on the [Notification] tab of the [Alarm] page (®page 115) and
the [E-mail] tab of the “Server” page (®page 131).
Notify of alarm occurrences to the designated IP addresses (Panasonic
alarm protocol notification)
This function is available only when a Panasonic device, such as the network disk recorder, is connected to
the system. When “On” is selected for “Panasonic alarm protocol notification”, the connected Panasonic device
will be notified that the camera is in the alarm state. The settings for Panasonic alarm protocol can be configured
in the Panasonic alarm protocol section of the [Notification] tab of the [Alarm] page. (®page 117)
24 Operating Instructions
4 Action at an alarm occurrence
To Next Page
Loading...
