3. Click the divided areas to be masked.
→ The clicked areas will be masked and will become white. To cancel masking, click the area again.
4. Click the [End] button after completing masking areas.
→ The borders on the image displayed on the [Image quality] tab will disappear.
IMPORTANT
• The mask area may move out of alignment when the JPEG/H.264 “Image capture mode” setting is
changed. Make sure to check the setting after changing the “Image capture mode” setting.
• The mask area may move out of alignment when “Extra zoom” is configured. Make sure to check the
setting after changing the “Extra zoom” setting.
Note
• When the [Reset] button is clicked, masking for all the masked areas will be canceled.
Operating Instructions 95
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
