33
Cable guide Cable guideConnected cable
b Accommodate the connected cables inside the
cable guide of the camera mount bracket.
IMPORTANT:
•To prevent the cables from being caught
when the base cover (accessory) is
attached, keep the cables inside the cable
guide.
n Attach the base cover (accessory) that was
removed according the steps in page 20.
m Use the bit for tamperproof screw (accessory)
to tighten the fixing screws provided on both
sides of the base cover (accessory).
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
, Remove the cover film from the dome cover.
Base cover
(accessory)
Base cover fixing screws
To Next Page
Loading...
