• The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are not
responsible for any accidents or damages occurring in case.
VMD area setting
[Select a preset position]
Select a preset position number to which the VMD area is to be set, and click the [Start] button.
When setting an area which is not at the preset position for the VMD area, select VMD activation in area “except
the preset positions”.
VMD information addition
[Information addition]
Select “On” or “Off” to determine whether or not to add VMD information to superimposed image data.
The VMD information can be searched by some Panasonic network disk recorders. Refer to the operating
instructions of the connected devices for further information about the functions and settings.
• Default: Off
Procedure for setting the VMD area
Set the areas to activate the VMD function.
Operating Instructions 145
13 Configure the alarm settings [Alarm]
To Next Page
Loading...
