Panasonic WV-SW598

[Viewnetcam.com]
• Server: The URL of the “Viewnetcam.com” service server will be displayed.
• Status: The registration status for the “Viewnetcam.com” will be displayed.
• Personal(Camera) URL: The URL of the camera registered for “Viewnetcam.com” will be displayed.
[UPnP]
• Port number(HTTP), Port number(HTTPS): The port number that is set for UPnP port forwarding will be
displayed.
• Status: The port forwarding status will be displayed.
• Router global address: The global address of the router will be displayed.
[Self check]
The self check result of the hardware will be displayed.
[Hardware information]
Information such as how many times the camera has been panning/tilting.
Note
• Refer to our website (http://security.panasonic.com/pss/security/support/info.html) for further
information about the contents of the displayed statuses (relating to the “Viewnetcam.com” service,
the UPnP function, or the self check).
19.4 Reset the settings/Reboot the camera [Default
reset]
Click the [Default reset] tab of the “Maintenance” page. (®page 48, page 50)
The settings and the HTML data of the camera can be initialized and reboot of the camera can be performed
on this page.
[Reset to the default (Except the network settings)]
Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Load the default HTML files (setup menu).]
Click the [Execute] button to reset the HTML files to the default.
It is impossible to operate the camera for about 3 minutes after the initialization.
Operating Instructions 207
19 Maintenance of the camera [Maintenance]