Panasonic WV-SW598

Note
• Even when “H.264” is selected, if “Off” is selected for “H.264 transmission”, only JPEG images are
displayed.
*1
It is not possible to configure this setting for both H.264(1) and H.264(2) simultaneously.
*2
It is necessary to designate the unicast port number when “Unicast port (MANUAL)” is selected for “Transmission type”.
*3
It is necessary to designate the multicast IP address when “Multicast” is selected for “Transmission type”.
Operating Instructions 95
11 Configure the settings relating to images and audio [Image/Audio]