User Manual For Cyclone LC Programmers 141
15.3 SAP Communication Handling Related Errors
$0031: System reset occurred
$0032: System is busy with other operations.
$0033: System is busy with too many inquiries.
$0034: System has not finished initialization.
15.4 SAP Algorithm Header Operation Handling Related Errors
$0061: Undefined header operation
$0062: Operation in algorithm header has failed.
15.5 SAP Operation Related Errors
$0081: SAP operation is not supported.
$0082: Target type mismatch
$0083: SAP operation canceled
$0084: Running algorithm failure
15.6 SAP Blank Check Range and Module Related Errors
$1001: Blank Check is not supported by this algorithm.
$1002: Blank Check algorithm was not found.
$1003: Blank Check operation failed
15.7 SAP Erase Range and Module Related Errors
$2001: Erase error, algorithm not supported
$2002: Erase error, algorithm not found
$2003: Erase error, module failed or canceled
$2004: Erase error, module failed, target is still secured
$2005: Erase error, module not performed, data is preserved
15.8 SAP Program Byte, Word, and Module Related Errors
$3001: Program error, algorithm not supported
$3002: Program error, algorithm not found
$3003: Program operation failed or was canceled
$3004: Program operation failed, write protected
$3005: Program error, Data size exceeds the limit
$300A: Error during reading data range, invalid data length
$300B: Error during reading data range, invalid start address
$300C: Error during reading data range, no target power
$300D: Error during programming data range, invalid data length
$300E: Error during programming data range, invalid start address
$300F: Error during programming data range, no target power
$3010: Error reported while running the custom test application (RT) on the target.
$3011: Error displaying feature
$3012: Error programming feature
$3013: Error overlaying feature
To Next Page
Loading...