User Manual For Cyclone LC Programmers 142
$3014: Error: Run Test Operation terminated
$3015: Error: Run Test Operation over character limit 255
$3016: Error run test operation failed
$3017: Error: unable to allocated memory during run test.
$3018: Error: Dynamic operation failure. Algorithm is not loaded. Check image settings.
$3040: Error: Program may cause the device to be secured permanently
15.9 SAP Verify Checksum Related Errors
$4001: Verify Checksum not supported
$4002: VC failed, invalid algorithm was used
$4003: VC operation failed or was canceled
$4011: VV command not supported
$4012: VV failed, invalid algorithm was used
$4013: VV operation failed or was canceled
15.10 SAP Verify Range and Module Related Errors
$5003: Error during verifying module.
15.11 SAP User Function Related Errors
$6003: Error during user functions.
15.12 SAP Trim Related Errors
$7001: Program Trim operation is not supported
$7003: No target response during a Program Trim operation
$7004: Program Trim error. Trim value is not set
$7007: Program Trim error. Trim value failed
$7008: Trim error. Trim value read failed
$7009: Trim value invalid, value is $00 or $FF
$700A: Trim value is invalid. Trim value is already programmed.
15.13 Unrecoverable Fatal Errors
$8001: Fatal Error: please contact PEmicro.
$8002: Fatal Error: please contact PEmicro.
$8003: Fatal Error: please contact PEmicro.
$8004: Fatal Error: please contact PEmicro.
$8005: Fatal Error: please contact PEmicro.
$8006: Fatal Error: please contact PEmicro.
$8007: Fatal Error: please contact PEmicro.
$8008: Fatal Error: please contact PEmicro.
$8009: Fatal Error: please contact PEmicro.
$800A: Fatal Error: please contact PEmicro.
$800B: Fatal Error: please contact PEmicro.
$800C: Fatal Error: please contact PEmicro.
$800D: Fatal Error: please contact PEmicro.
To Next Page
Loading...