P&E Microcomputer Systems Cyclone LC Series - Page 79

User Manual For Cyclone LC Programmers 79
8.2.4.4.7 getLastErrorAddr
uint32_t getLastErrorAddr(uint32_t cycloneHandle);
If the “getErrorCode” function returns a non-zero value (indicating an error has occurred), this
routine can be used to query the address where the error occurred.
8.2.4.4.8 getDescriptionOfErrorCode
char *getDescriptionOfErrorCode(uint32_t cycloneHandle, uint16_t errorCode);
This function returns a description of the error code.
8.2.4.4.9 resetCyclone
bool resetCyclone(uint32_t cycloneHandle, uint32_t resetDelayInMs);
This function performs a hard reset of the Cyclone. It is the same as pressing the reset button. This
is considered a legacy call and does not need to be called by the application.
8.2.4.5 Configuration / Image Maintenance Calls
8.2.4.5.1 getImageDescription
char *getImageDescription(uint32_t cycloneHandle, uint32_t imageId) ;
This function returns the description of a particular image stored on the Cyclone (internal Flash or
external memory card). This description is specified by the user when the image is created.
@returnvalue The error code of the DLL or Cyclone
@parameter cycloneHandle
The handle of the Cyclone from which to request the error
address.
@returnvalue
The memory address where the last programming error
occurred.
@parameter cycloneHandle The handle of the Cyclone to retrieve the error code description.
@parameter errorCode The error code to check.
@returnvalue
A pointer to a null-terminated character string that contains the
error code description.
@parameter cycloneHandle The handle of the Cyclone that will be reset.
@parameter resetDelayInMs
The reset delay, specified in milliseconds. The delay should be
at least 5500 ms.
@returnvalue
True if reset was successful
False otherwise
@parameter cycloneHandle The handle of the Cyclone to get an image description.