Pandora Immo

16
Pandora Immo
Using app
Paring of mobile app with immobilizer unit will be performed only when
ignition is switched on in radio coverage zone. Availability and unavailability
of immobilizer tags do not affect the app’s operation.
Every time when you enter the app, PIN-code is required to prevent the
entrance in case of theft of a phone. Factory preset PIN-code is 1-1-1-1. After
entering correct PIN-code, the app allows access to control immobilizer.
There is a limited number of attempts to enter mobile app PIN-code.
If three attempts to enter PIN-code were incorrect, immobilizer will block
access to the app. Procedure to reset the number of incorrect PIN attempts
should be performed to restore the operation. Reset will be performed when
PIN-code of the base unit is entered (detailed description of ‘PIN-code input’,
page 20).
Control
I
n
r
a
d
i
o
z
o
n
e
I
n
c
o
n
n
e
c
t
i
o
n
U
n
a
v
a
i
l
a
b
l
e
1
2
1
-70dBm
2,92V
-50dBm
2,94V
D
isable
In radio zone
Tag
2
Tag
12,03V
Enable Valet mode
No tag
Disconnect the deviceSettings menu
Maintenance/valet mode
Immobilizer status indicator
Open door status
Tag’s button press
Maintenance/valet mode
is enabled/disabled
On-board voltage
Radius of tag’s detection zone
Status output
Number of recorded remotes
into the system’s memory
Tag’s frequency
Tag’s battery voltage