Algorithms of unconditional engine blocking
and blocking when starts moving
Blocking when there is motion is original system setting. Engine blocking
algorithm depends on adjusting that was set via mobile app. There are two
blocking options:
1. When there is motion – engine blocking will occur in whatever modes
(immobilizer, Antihijack 1, Antihijack 2) only on fact of motion.
2. Unconditional engine blocking – engine blocking will occur in
whatever modes (immobilizer, Antihijack 1, Antihijack 2) without motion.
Blocking operates throughout the ignition is being switched on.
WARNING!
THIS ALGORITHM CAN BE SET VIA MOBILE APP.
Status output
Analogue negative output of immobilizer Pandora Immo is designed
to work with additional devices of third-party manufacturers. Status output
operation algorithm can adjust the event when negative potential signal will
be sent to the status output of the immobilizer base unit:
1. When immobilizer tag is detected.
When the tag is in radio coverage zone of immobilizer, negative potential
signal will be sent to the status output until tag is lost.
2. When blocking is occurred.
When blocking of whatever modes (immobilizer, Antihijack 1, Antihijack
2) is enabled, negative potential signal will be sent to the status output until
algorithm of blocking is disabled.
WARNING!
THIS ALGORITHM CAN BE SET VIA MOBILE APP.
To Next Page
Loading...
Need help?
General
