Settings menu
Control
Return to ‘Control’ main menu.
App
SOUND – enabling/disabling of sound notifications in the app.
RINGTONE – selection of notification ringtone.
NOTIFICATIONS VIBRATION – enabling/disabling of vibration for
receiving notifications.
Settings
CHANGING PIN-CODE – changing of PIN-code to enter app and service
PIN. When changing the code via mobile app, service PIN-code to enter
programming menu will be changed, herewith the code will consist of the
first three digits of app’s new PIN-code. Changed PIN should be written down
on page 13.
SOUND SIGNALS OF VALET MODE – enabling/disabling of sound signals
in maintenance/valet mode.
SOUND SIGNALS WHEN TAG IS LOST – enabling/disabling sound signals
of blocking activation at whatever algorithm (immobilizer, Antihijack 1,
Antihijack 2).
Advanced settings
RADIO RELAY MOTION SENSOR – enabling/disabling of the base unit
motion sensor. When enabling sensor, engine blocking will be performed
only when moving and the ignition is switched on. When disabling sensor,
engine blocking will be performed after the ignition is switched on without
taking into account the motion.
RADIO RELAY MOTION SENSOR SENSITIVITY – setting of built-in
accelerometer sensitivity in immobilizer unit. Set sensitivity from 0 to 100.
Level 0 is lowest sensitivity level,100 is the highest one.
ANTIHIJACK MODE – selection of Antihijack mode (Antihijack 1,
Antihijack 2). Algorithm operation descripion is in ‘Antihijack mode’ section.
STATUS OUTPUT – selection of status output mode (Tag is in radio zone,
Engine blocking). Algorithm operation descripion is in ‘Status output’ section.
TAG’S DETECTION THRESHOLD – changing of radius of tag’s detection
To Next Page
Loading...
