This signal will sound:
1. When the ignition is being switched on (three beeps).
2. Every minute when the ignition is switched on (three beeps).
‘Blocking is enabled’ – sound signal will emitted when there is any
blocking algorithm (immobilizer, Antihijack 1, Antihijack 2).
Single tones that become more frequent – warning signal that signifies the
start of any blocking algorithm.
‘Maintenance/valet mode’ – this signal means that maintenance/valet
mode is enabled.
This signal will sound:
1. When enabling/disabling maintenance/valet mode (double beep).
2. Every minute when the ignition is switched on (double beep).
Sound signals of programming menu
‘Enter PIN-code’ 1 beep – input the first digit of PIN-code.
‘Enter PIN-code’ 2 beeps – input the second digit of PIN-code.
‘Enter PIN-code’ 3 beeps – input the third digit of PIN-code.
Up to 10 single beeps – PIN-code digit entering.
Up to 6 prolonged beeps – selection of operation modes or system
programming levels.
Ringtone – PIN-code is incorrect.
IMMOBILIZER TAG
Immobilizer tag is intended for owner’s authorization in Bluetooth
coverage zone. The system produces and sending data throughout
protected (AES-128 encryption) interactive dialog channel of exchange of
authorization codes on the Bluetooth frequency. Built-in accelerometer
(motion sensor) that reacts on changing of tag’s location is used to save
energy. Tag has control button to activate/deactivate maintenance/valet
mode (see ‘Maintenance/valet mode’, page 13). Built-in LED indicator on tag
shows battery level and can help find a lost tag.
To Next Page
Loading...
