Pandora SMART PRO V3 - Emergency System Control; PIN Code Entry for Emergency

35
U S E R M A N UA L
CONTROL OF THE SYSTEM IN CASE OF EMERGENCY
The system has emergency ways to deactivate security and anti-hijack functions (using the VALET
button and the “Secret PIN-code”) in case of loss or failure of control devices or in case of discharge of a
battery (when you cannot replace it or charge).
Before using emergency system control, check the system and vehicle control devices: check a
battery, turn on a device in accordance with its manual (if required).
If all devices are working, try to make a primary vehicle diagnosis: check the vehicle original control
device, vehicle battery charge level, gearbox selector position, check information on the dashboard.
!
THE SYSTEM CAN BE CONTROLLED FROM A PHONE USING DTMF COMMANDS.
0* – Disarming.
998*xxxх – Deactivate authorization devices (Immobilizer and Anti-Hijack functions), where хххх is
the “Secret PIN-code” written on the Owner’s personal card under the protective layer.
1*– Arming.
888* – Activate authorization devices (Immobilizer and Anti-Hijack functions).
! READ THE PROCEDURE FOR ENTERING THE PIN-CODE BEFORE USING EMERGENCY FUNCTIONS.
ENTERING THE PIN-CODE
The code must be entered only when the base unit is powered and the ignition is off. The PIN-code can
be entered using the external or located on the base unit VALET button. The digits input and correct
input is indicated by the external or located on the base unit LED indicator.
•Enter the first digit • Press the button the number of times equal to the first digit. Pauses between
presses should not exceed 1 second. Each pressing will be confirmed with an orange LED indicator
flash. Pause for more than 1 second, a red LED indicator flash and a short sound single of the Beeper
confirm the input of the first digit. Then you can enter the next digit.
•Enter the second digit • Press the button the number of times equal to the second digit. Pauses
between presses should not exceed 1 second. Each pressing will be confirmed with an orange LED
indicator flash. Pause for more than 1 second, a red LED indicator flash and a short sound single of
the Beeper confirm the input of the second digit. Then you can enter the next digit.
•Enter the third digit • Press the button the number of times equal to the third digit. Pauses between
presses should not exceed 1 second. Each pressing will be confirmed with an orange LED indicator
flash. Pause for more than 1 second, a red LED indicator flash and a short sound single of the Beeper
confirm the input of the third digit. Then you can enter the next digit.