Pantech Marauder - Page 31

STARTER MODE l BASIC OPERATION
30
Adding a Wi-Fi network
1 Tap Apps from the Home Screen and tap Settings > Wireless &
network.
2 Tap OFF next to Wi-Fi to activate. The icon turns orange when the
function is on.
3 Tap Wi-Fi.
4 Tap ADD NETWORK.
5 Enter the Network SSID and select the security type among None,
WEP, WPA/WPA2 PSK and 802.1x EAP. Aside from None, you must
enter a password for the network.
6 Tap Save.
Disconnecting a Wi-Fi network
1 Tap Apps from the Home Screen and tap Settings > Wireless &
network.
2 Tap Wi-Fi.
3 Tap the network that is connected to the Marauder
TM.
4 Tap Forget to disconnect from the network.
Note You can also disconnect from the Wi-Fi network by pressing
and holding the network and tapping Forget network.
Setting advanced features
1 Tap Apps from the Home Screen and tap Settings > Wireless &
network.
2 Tap OFF next to Wi-Fi to activate. The icon turns orange when the
function is on.
3 Tap Wi-Fi.
4 Tap
B
and tap Advanced.
x Tap Regulatory domain, and select and tap a channel for the
domain.
x Tap Keep Wi-Fi on during sleep and specify when the Marauder
TM
should switch from the Wi-Fi network to mobile network.
x Tap Avoid poor connections if you do not want to use a Wi-Fi
network that has a poor connection.
Setting WPS connection
1 Tap Apps from the Home Screen and tap Settings > Wireless &
network.
2 Tap OFF next to Wi-Fi to activate. The icon turns orange when the
function is on.
3 Tap Wi-Fi.
4 Tap
B
and tap WPS connection.
x Tap Button connection or PIN connection, and follow the
instructions.