Operations Manual, HPA2, Compact Outdoor SSPA 208495 REV B 13
2.0 Introduction
This section provides information for the initial inspection, installation, external connections,
and shipment of the Compact Outdoor SSPA unit.
2.1 Inspection
When the unit is received, an initial inspection should be completed. First ensure that the
shipping container is not damaged. If it is, have a representative from the shipping company
present when the container is opened. Perform a visual inspection of the Compact Outdoor
Amplifier to make sure that all items on the packing list are enclosed. If any damage has
occurred or if items are missing, contact:
Teledyne Paradise Datacom LLC
328 Innovation Park, Suite 100
State College, PA 16803
Phone: 1 (814) 238-3450
Fax: 1 (814) 238-3829
2.2 Prime Power Connection [MS3102E20-3P]
The Prime power connector is a 3-pin circular connector, J7. The power supplies provide
universal AC input by using auto-sensing power supplies. The AC input can operate over a
range of 90-265 VAC, at 47 to 63 Hz. The power supply is also power factor corrected,
enabling the unit to achieve a power factor greater than 0.93.
The highest output power levels, >70 W @ Ku-Band and >100 W @ C-Band should be
powered only from a 180–265 VAC source. This will keep AC line currents to safe operating
levels for the internal EMI filter and associated circuitry. The AC Line input connector
configuration is given in Table 2-1. The prime power vs. RF output power is summarized in
Table 2-2. An option for 110 VAC prime power is available for the higher-powered units.
WARNING! Always terminate the RF input and output connectors prior to
applying prime AC input power!
Pin # on J7 Connection
A L1
B GND
C L2/N
Table 2-1: AC Line Input Connector
Section 2: Installation
To Next Page
Loading...