Paradise Datacom 205486 REV F - Figure 2-3: RF Output Side of C Band Compact Outdoor SSPA; RF Output (J2); Switch Port (J6) [MS3112 E10-6 S]; Table 2-5 Switch Port (J6) Pin-Outs

Operations Manual, HPA2, Compact Outdoor SSPA 208495 REV B 17
2.5.4 Switch Port (J6) [MS3112E10-6S]
When used in a 1:1 redundant system, the waveguide switch must be connected to the switch
port of each amplifier (MS3112E10-6S). See Table 2-5. It mates with MS3116F10-6P.
2.5.5 RF Output (J2)
The RF Output is brought out through waveguide in the Compact Outdoor Amplifier. Figure
2-3 shows the output of a C-Band Compact Outdoor Amplifier. The Ku-Band amplifiers have a
WR75 grooved flange, while the C-Band and X-Band amplifiers have CPR style grooved
flanges (CPRG-137 for C-Band; CPRG-112 for X-Band). Ka-Band amplifiers utilize a WR28
grooved flange. S-Band units are fitted with Type N (F) connectors at the RF Output.
Table 2-5 Switch Port (J6) Pin-Outs
Pin # on J6 Connection Pin # on J6 Connection
A N/C D N/C
B N/C E POS 2
C +28 VDC F POS 1
Figure 2-3: RF Output Side of C Band Compact Outdoor SSPA
RF OUT
J2
Warning! Radiation hazard when un-terminated. Do not
operate the SSPA without terminating the RF Output
(J2). Do not look directly into the RF Output waveguide.