Esprit 728 Ultra & 738 Ultra 37
Part 10: Other Options
10.1 Telephone Line Monitoring (TLM)
Feature Select Programming
D
Address 086; Keys [2ND] and [1]
Default: TLM Disabled
When enabled, the system verifies the existence of a telephone line every 4 seconds. If the system detects a trouble, the LED will
flash ON for 1 second and OFF for 1 second. TLM will activate a trouble when less than 3 volts is detected in four consecutive tests.
Please note that when the dialer detects a telephone ring, the TLM test stops for 1 minute. There are three TLM options, which
are set as indicated in Table 15 below:
1. OFF/ON: Line test failure will generate a trouble indication; key [0] will illuminate on the keypad (LED keypad only).
2. ON/OFF: Line test failure will generate a trouble indication and an alarm if the system is armed.
3. ON/ON: Line test failure will generate a trouble indication and cause a silent zone or a silent panic alarm to switch to audible mode.
[
ENTER] + Installer code + [0] [8] [6] + [2ND] and [1] ON/OFF + [ENTER]
10.2 Dialing Options
Feature Select Programming
D
Address 086; Key [7]
Default: Pulse Dialing
You can program the control panel to use the pulse dialing or tone/DTMF dialing format.
Key [7] OFF: Pulse Dialing
Key [7] ON: Tone/DTMF Dialing
[
ENTER] + Installer code + [0] [8] [6] + [7] ON/OFF+ [ENTER]
10.3 Dialing Pulse Rates
Feature Select Programming
D
Address 086; Key [0]
Default: Pulse Europe 1:2
This selection determines the ratio between "pulse" time and "quiet" time. Select Pulse Europe for a 1:2 ratio and select Pulse
USA for 1:1.5. Must be set to pulse dialing mode, refer to Dialing Options.
Key [0] OFF: Pulse Europe 1:2
Key [0] ON: Pulse USA 1:1.5
[
ENTER] + Installer code + [0] [8] [6] + [0] ON/OFF + [ENTER]
10.4 Keypad Panic Options
Feature Select Programming
D
Address 088; Keys [1] to [6]
Default: Disabled
This feature will generate an alarm when the user presses two specific keys on the keypad simultaneously for 2 seconds as
follows:
Key [1] ON = Panic 1 (keys [1] and [3]) enabled
Key [2] ON = Panic 2 (keys [4] and [6]) enabled
Key [3] ON = Panic 3 (keys [7] and [9]) enabled
Keypad panic options:
Key [4] OFF = Panic 1 silent
Key [4] ON = Panic 1 audible
Key [5] OFF = Panic 2 silent
Key [5] ON = Panic 2 audible
Key [6] OFF = Panic 3 silent
Key [6] ON = Panic 3 fire alarm
[
ENTER] + Installer code + [0] [8] [8] + [1] to [6] ON/OFF + [ENTER]
Table 15: Telephone Line Monitoring (TLM)
Key
[2
ND][1]
OFF OFF - TLM is disabled (default)
OFF ON - TLM generates a trouble only
ON OFF - generates an alarm if armed
ON ON - silent alarm becomes audible
(address 086, key [9] has to be OFF)