EasyManuals Logo

Paradox Esprit 748 express + User Manual

Paradox Esprit 748 express +
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
14
1) Press [ENTER] + Installer Code
2) The [ENTER] key will flash indicating
you are in programming mode
3) Enter the desired 3-digit address
4) The keypad will display the 2-digit
data currently saved at this address
as described in figure 23
5) Enter 2-digit data; after entering data
you do not need to press enter, the
software will automatically save the
data into the selected address
6) Return to step 2 to continue
programming or press [CLEAR] to exit
programming mode
4.2.2 Hexa Streamlined Section Programming
This is an alternate method to Hexa Programming. The addresses (000-043 and 300-527)
programmed in the Hexa Programming method are grouped into 67 sections where each
section contains four addresses (i.e. section 00 = addresses 000-003). Using this method
allows you to program 8 digits (4 addresses) without having to exit and re-enter addresses.
When entering the final digit, the software will automatically advance to the next section.
Example: If you complete the "Programming Guide" with the desired data, you
can program the 68 sections by entering all digits without pressing [ENTER] or
entering any other addresses. This greatly reduces programming time.
Note: the keypad will not display the current data in the Hexa Streamlined Programming
method. To program using the Hexa Streamlined Section method:
1) Press [ENTER] + Installer code + [7]
2) The [ENTER] and [2ND]
keys will flash to indicate you are in streamlined programming mode
3) Enter 2-digit section (00-67)
4) The [ENTER] key will remain on and the [2ND] key will turn off
5) Enter 8-digit data to program the section
6)
The keypad will "beep" to indicate that the section has been programmed, data is saved
and the software has advanced to the next section
7) Return to step 4 to continue programming or press [CLEAR] to exit programming mode
4.2.3 Decimal Programming
Addresses 044 to 061 are programmed using the Decimal Programming method. Values
entered must contain three digits from 000 to 255 (where the [10] key = 0). To program using
the Decimal Programming method:
Programming Methods

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Paradox Esprit 748 express + and is the answer not in the manual?

Paradox Esprit 748 express + Specifications

General IconGeneral
BrandParadox
ModelEsprit 748 express +
CategoryControl Panel
LanguageEnglish

Related product manuals