6 User Guide
Trouble Display
Your alarm system continuously monitors several trouble conditions that can be reported directly to your
monitoring station. When a trouble condition occurs, the [
TBL] key will illuminate. Press the [TBL] key, and the
keypad will illuminate a number corresponding to the trouble the system is experiencing. Except for the Timer
Loss trouble, contact your monitoring station or installer to resolve the trouble condition.
NOTE: If the keypad emits a
BEEP every 5 seconds whenever a new trouble condition has occurred, press the
[
TBL] key to stop the “Trouble Beep”.
Accessing the Trouble Display
Press
[TBL]
Key / LED
Lit
Trouble Type Trouble Details
[1] Wireless Zone Low Battery The batteries for one of the system’s wireless
devices needs to be replaced.
[2] Power Trouble The control panel is experiencing power trouble.
[3] Bell Trouble There is a bell disconnect/overload on the control
panel.
[4] Communication Trouble Your alarm system, if monitored, could not
communicate with the monitoring station.
[5] Tamp e r/Z o ne Wir i ng F ai l ure A w iri ng p rob l em is occ u rri n g o n o n e o r m o re
devices.
[6] Module Tamper Trouble A device’s anti-tamper switch has been triggered.
[7] Fire Loop Trouble One of the zones is in fire loop trouble.
[8] Timer Loss Your alarm system’s clock must be reprogrammed.
See Setting the Time and Date on page 5 to set your
system’s time and date.
[9] Wireless Zone Supervision Loss One or more wireless zones are no longer
communicating with the system.
[0 (10)] Module Supervision Loss One or more modules are no longer communicating
with the system.
[16] /
[
SLEEP]
Keypad Fault There is a problem with one of your system’s
keypads
To Next Page
Loading...
Need help?
General
