Arming / Disarming 11
One-Touch Arming
If enabled by your installer, you can arm your system with the following arming
methods simply by pressing and holding (for three seconds) the appropriate
function key. You do not have to enter your User code. See Figure 1 on page 6
for the location of the function keys. Table 1 shows what function keys can be
used for one-touch arming.
* = To Instant arm your system using one-touch arming, press and hold the
[
STAY ARM] key and then during Exit Delay mode, press and hold the [STAY
ARM] key once more.
Auto-Arming
You can set the time that the system will arm itself automatically. There are two methods of auto-arming:
Timed Auto-Arming
Your installer can set the Timed Auto-arming method to function in either Regular or Stay arming modes. A sixty-second Exit
Delay sequence will begin prior to your system automatically arming itself at the programmed time. To set the Timed Auto-
arming feature:
No Movement Auto-Arming
Your system can be programmed to send a report to your monitoring station and/or arm the system if there is no activity in the
system during a specified period of time. Your installer can set No Movement Auto-arming to function in either Regular or Stay
arming modes. Talk to your installer for more information.
Table 1: One-touch Arming Keys
Function Key Arming Method
key
Stay arm (page 10)
key
Instant arm* (page 10)
key
Regular arm (page 9)
Program
time
menu ok
Magellan_EU03.fm Page 11 Friday, December 3, 2004 2:33 PM
To Next Page
Loading...
Need help?
General
