Access System Features by Phone 25
Chapter 4: Access System Features by Phone
This chapter covers Magellan’s remote access feature that transforms any external touch-tone telephone into a keypad. Through the
telephone, you will be able to arm/disarm your system, listen to any messages, activate outputs and more.
Access System Features by Phone
Due to Magellan’s voice-assisted remote features, any touch-tone telephone can be turned into a keypad. Arm/disarm Magellan,
activate/deactivate Magellan’s PGM outputs, record/listen to messages and even turn Magellan into a speakerphone all via your
telephone. Using detailed voice prompts to guide your way, remote access to Magellan is as easy as picking up the telephone.
Please note the following:
• The following instructions pertain to entering commands and/or data through your telephone’s keypad. Therefore, whenever you are
instructed to perform an action and/or enter data, do so on your telephone’s keypad.
• Magellan will automatically hang up if no action is performed after 2 minutes.
• Press the [*] key at any time to exit and have Magellan hang up.
• When Magellan is in speakerphone mode, key [16] from the center keypad will flash rapidly.
Step 1: Call Magellan from any touch-tone telephone
Pick up your telephone and dial the number of the
telephone line that your Magellan console is connected
to (usually your home number). If the telephone line
that Magellan is connected to is shared with an
answering service or answering machine, you have to
override the answering service or machine. To override
the answering service or machine:
Step 2: Enter your user code
Use the same User code that you use with the Magellan console.
Call
Magellan,
wait one
or two
rings and
then hang
up
Wait 10
seconds
Call
Magellan
again
Magellan_EU03.fm Page 25 Friday, December 3, 2004 2:33 PM
To Next Page
Loading...
Need help?
General
