STEP KEY DESCRIPTION
14. NEXT MON is flashing. NO is displayed.
15. + Change NO to YES. Step through remaining days and select YES
for TUE, WED, THU, FRI and HOLIDAY A.
16. PROGRAM Advance to INPT (configure inputs) header.
17. NEXT 1st input is shown with input # flashing.
18. NEXT Input type is flashing.
19. +/- Select F (Fahrenheit).
20. NEXT CAL (calibration) offset is shown.
21. +/- Calibrate sensor if necessary.
22. PROGRAM Advance to EVNT SENS (sensor event) header.
23. NEXT First sensor event is shown with event # flashing.
24. NEXT Sensor number is flashing. NONE indicates that a sensor has not yet
been selected.
25. + Select sensor 1. 1- F is displayed.
26. NEXT Channel number 1 is flashing. This is the desired channel.
40
To Next Page
Loading...