Parker 650V series - Page 12

101 pages

To Next Page

To Previous Page

1-2 Getting Started

650V AC Drive

Lefflersgatan 1, SE-754 50 Uppsala, SWEDEN +46 (0)18-65 70 00 +46 (0)18-10 74 78 info@regal.se www.regal.se

Main Page

Default Chapter7
- Table of Contents7
Chapter 1 Getting Started11
Introduction11
- Equipment Inspection11
- Storage and Packaging11
About this Manual11
- An Overview of the Drive13
Component Identification13
Chapter 3 Installing the Drive15
Mechanical Installation15
- Mounting the Drive15
- Ventilation15
Electrical Installation16
- Wiring Instructions16
- Connection Diagram17
Optional Equipment20
Chapter 4 Operating the Drive25
Pre-Operation Checks25
Initial Start-Up Routines25
- Local Control Operation26
- Remote Control Operation26
- Set-Up as an Open-Loop Drive (V/F Mode)27
- Set-Up Using the Sensorless Vector Mode27
- Tuning the Drive to Your System29
- The Keypad31
  - Control Key Definitions31
Controlling the Drive Using the Keypad31
- Display Indications32
- Drive Status Indications32
- Quick Application Selection32
- Selecting the Menu Detail33
The DIAGNOSTICS Menu33
The Menu System34
- Changing the Default Operating Frequency35
- How to Change a Parameter Value35
- Resetting to Factory Defaults (2-Button Reset)35
Special Menu Features35
- Changing Direction in Local Control36
- Selecting Local or Remote Control36
- Password Protection37
Chapter 6 Programming Your Application39
MMI Parameters39
- Product-Related Default Values54
Chapter 7 Trips and Fault Finding59
Trips59
- Trip Warning Message59
- What Happens When a Trip Occurs59
- Resetting a Trip Condition59
- Using the Keypad to Manage Trips59
- Hexadecimal Representation of Trips63
Fault Finding64
- Routine Maintenance & Repair65
Routine Maintenance65
Repair65
- Saving Your Application Data65
- Returning the Unit to Parker SSD Drives65
- Disposal65
Chapter 9 Technical Specifications67
- Understanding the Product Code67
- Environmental Details69
- Power Details69
- Electrical Ratings70
- Supply Short Circuit Rating71
- User Relay71
- Analog Inputs/Outputs71
- Analog Outputs71
- Digital Inputs72
- Digital Outputs72
- Cabling Requirements for EMC Compliance72
- Internal Dynamic Braking Circuit73
- External Brake Resistor73
- Supply Harmonic Analysis (230V Filtered)74
- Supply Harmonic Analysis (400V Filtered)75
- Supply Harmonic Analysis (230V Unfiltered)76
- Supply Harmonic Analysis (400V Unfiltered)77
Chapter 10 Certification for the Drive79
Requirements for EMC Compliance79
- Earthing Requirements79
Requirements for UL Compliance79
- Certification for the Drive81
European Directives and the CE Mark81
- CE Marking for Low Voltage Directive81
- CE Marking for EMC - Who Is Responsible81
EMC Compliance81
EMC Compliance82
- Serial Communications85
Connection to the P3 Port85
Chapter 12 Applications87
The Default Application87
How to Load an Application87
Application Description87
- Control Wiring for Applications87
- Application 1 : Basic Speed Control (Default)88
- Application 2 : Auto/Manual Control90
- Application 3 : Preset Speeds92
- Application 4 : Raise/Lower Trim94
- Application 5 : PID96
- Application 6 : Auxilliary Comms98

Parker 650V series - Page 12

Table of Contents

Other manuals for Parker 650V series

Related product manuals