Parker Hannifin
Non-Volatile
Command Description
BRESET Disable battery backup
ELOAD Load system parameters
ERASE Clear the EEPROM
ESAVE Save system parameters
FIRMWARE Firmware upgrade/backup
FLASH Create user image in flash
PBOOT Auto-run program
PROM Dump burner image
Operating System
Command Description
ATTACH Define attachments
CONFIG Hardware configuration
CPU Display processor loading
DEF Display the defined variable
#DEFINE Define variable
DETACH Clear attachments
DIAG Display system diagnostics
ECHO Character echo control
HELP Display command list
IP IP address
MODE Binary data formatting
PASSWORD Block uploading programs from board
PERIOD Set base system timer period
PLC Switch to a PLC prompt
PROG Switch to a program prompt
REBOOT Reboot controller card
STREAM Display stream name
SYS Return to system prompt
VER Display firmware version
Basic Setup 35
To Next Page
Loading...
Need help?
General
