Parker GT Series - Page 66

Appendix A – Specifications 65
Gemini GEM-VM50 – 50 Pin Breakout Module
Use the 50 pin breakout module for access to individual terminals on the 50 pin
DRIVE I/O connector. The GEM-VM50 includes the cable above.
Description: Part Number:
50 pin Breakout Module (with Cable) GEM-VM50
50 pin Breakout Module (without cable) 01-016986-01
Null Modem Cable – 9 Pin D-Connector to 9 Pin D-Connector
Use this cable for RS-232 communications between the Gemini drive and a
terminal. Note that this is not a “straight-through” cable; pins 2 and 3 are crossed,
making it a “null-modem” cable.
Part Number: 71-016939-10
CE Cable: Yes, if installed according to instructions in Appendix C
Connector: 9 pin female D-subminiature connector on each end
Shield
Black
Red
Green
Yellow
Gray
Brown
Blue
Violet
Red
Gray
Brown
Blue
Violet
White
Orange
White
Orange
Red
N/C
N/C
N/C
N/C
N/C
N/C
N/C
x
x
x
x
x
x
x
x
x
x
Black
Green
Yellow
5
6
3
2
1
7
4
8
9
5
6
2
1
3
4
7
8
9
Cable – RS-232 Null Modem
Gemini GC-50 – 50 Pin Connector
The Gemini GC-50 is a 50 pin breakout module that connects directly to the 50 pin
DRIVE I/O connector. Dimensions are shown below.
CAUTION
Connect wires to the GC-50 before installing it in the Gemini drive. This will avoid
damage that may be caused by wiring the GC-50 while it is attached to the drive.
Dimensions in inches (millimeters)
GC-50
12 4
1918 20 21 22 302423 2625 2827 29 343231 33
131210 11 171614 15953867
35 3736 3938 474140 4342 4544 46S4948 50
3.05 (77.5)
2.13 (54.0)
0.138 (3.5)
GC-50 Dimensions
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com