GB/IE/NI/CY/MT
11
Do not pull, carry or fix the device by the mains cable.
Only use extension cables which are splashproof and intended for
outdoor use. Always fully unroll a cable reel before use. Check the
cable for damage.
Unplug the mains plug from the socket before carrying out any
work on the device and when it is not being used.
Extension cables must not have a smaller cross-section than rubber
hose lines marked with H07RN8-F. The cable length must be 10 m.
The strand cross section of the extension cable must be at least
2.5 mm².
Extension cables and power cables must be checked regularly.
Defective cables or those which are not intended for this purpose
must not be used.
If the device is damaged, it must not be used and must be repaired
by a qualified person.
If you are not using the device for a longer period of time, it must
be stored dry and protected from the effects of weather.
This device must only be connected to power supplies with the
appropriate current draw. It should be correctly connected to a
230 V/50 Hz shockproof socket. When doing this, also compare
the details on the rating plate.
For your own safety, consult an electrician if you are uncertain
when connecting electrical parts.
Ensure that the sockets and connectors are protected against moisture.
Do not use the device in the rain.
Select a position where it cannot fall over.
Make sure that the glow wire hard foam cutter, the plug and extension
cable are positioned so that they are protected from water.
Always unplug all plugs before you carry out any work on the
glow wire hard foam cutter.
Outdoors, never use connectors, adapters, extensions or connecting
cables which are not approved for outdoor use.
Position the cables such that they are not causing an obstruction to
a path or can be damaged.
After assembling the device, you must always be able to reach
the plugs of the devices at any time. They must not be built over or
built in, so that, in the event of an emergency they can always be
pulled out.
If the glow wire hard foam cutter malfunctions, unplug the mains
plug immediately. Do not try to repair the glow wire hard foam
cutter yourself, as this poses a risk to your health and that of others.
In addition, any guarantee or warranty claim will be voided.
To Next Page
Loading...
