31
• In the case of a malfunc-
tion or defect during op-
eration, the device must
be switched off immedi-
ately and the mains plug
unplugged. For possible
causes of a malfunc-
tion: Troubleshooting,
p.40. Or, contact our
service centre.
• Note that the user is re-
sponsible for any acci-
dents or risks to others
and their property.
• Observe noise protection
rules and other local reg-
ulations.
Preparation
• Protect yourself against
splashing water or dirt
by wearing protective
goggles and suitable pro-
tective clothing.
• Aerosols may be pro-
duced during the use of
pressure washers. Inhal-
ation of aerosols may be
harmful to health. De-
pending on the applica-
tion, the use of fully shiel-
ded nozzles (e.g. surface
cleaners) can significantly
reduce the emission of
aqueous aerosols. De-
pending on the environ-
ment to be cleaned, wear
a suitable respirator of
class FFP2 or compar-
able to protect against
the inhalation of aerosols
if the use of a fully shiel-
ded nozzle is not pos-
sible.
• Do not work with a dam-
aged or incomplete
device or one which has
been converted without
the permission of the
manufacturer. Before
commissioning, have a
specialist check that the
required electrical pro-
tective measures are in
place.
• The device may only be
connected to a power
outlet that has been in-
stalled by an experienced
electrician in accordance
with IEC60364-1.
• Prior to use, always
check the power cord
and extension cord for
signs of damage or wear
and tear. If the cord is
damaged during use, it
must be disconnected
from the supply network
immediately. DO NOT
TOUCH THE CABLE BE-
To Next Page
Loading...
