PAX S800 - Page 43

www.123send.net
123 - axept S900 User Guide v1.7
42
The following process shows how to manually configure the Ethernet settings if you do not wish to use DHCP:
01
From the Network Settings menu, highlight ‘Ethernet’ using the
and keys on the keypad (or press the key on the keypad)
and press the key on the keypad to continue.
02
To use a fixed IP rather than DHCP, press the key.
03
Enter the IP address.
(To enter a ‘.’ [dot], press the key twice on the keypad).
Press the key on the keypad to continue.
04
Enter the Subnet mask for the network. Press the key on the
keypad to continue.