www.123send.net
123 - axept S900 User Guide v1.7
1.4 Initial Terminal Setup
Insert the thermal paper roll into the axept® S800 terminal.
• Pull lever on the terminal to open the lid (as highlighted)
• Insert paper roll leaving at least 1cm exposed
• Close Lid
Turn the axept® S800 over so the connections on the underside are
visible.
Connect the power supply into the socket labelled ‘Power’ (as
highlighted).
Connect the Ethernet cable (providing internet connectivity) to the port
labelled ‘LAN/RS232B’ (as highlighted).
Once connected, run the cables through the cable management
sections of the axept® S800 (as shown left).
This ensures that the cables are protected and the axept® S800 terminal
will sit flat on the desk/counter.
To Next Page
Loading...
