PBI Dansensor MAP Check 9000 - Connection

PBI-Dansensor A/S COPYRIGHT © PBI-220047-F 01/2008
9
MAP Check 9000 - User Manual 3. Connection
3. Connection
3.1. MAP Check 900X-1/2/4
•Pump control signal for external pump control (10-32VDC)
•Alarm relay outputs
•System error / Ready relay output
•Current/voltage outputs (optional)
•CAN bus (optional)
 Fan / dust filter
 Mains voltage
 Mains fuse
 RS232C port for serial communication with PC, etc.
 ST1
 ST2
 Gas in
 Gas out
 Rating plate
ST1 1,2: Pump control signal, 10-32VDC input (for external pump control)
3,4: O
2
alarm 1 relay. Max. 48V, 1A
5,6: O
2
alarm 2 relay. Max. 48V, 1A
7,8: System error / Ready relay. Max. 48V, 1A
ST2 1,2: * Reserved for current output (optional) (1+, 2-)
3,4: * Reserved for CAN bus (optional) (3+, 4-)
5,6 * Reserved for 24VDC output (optional) (5+, 6-)
* Other connection will be marked with a text on the back of MAP Check 9000
3
2
4
7
8
5
6
1
9