PBI DCH-5000P - Ethernet Input Settings; Outputs Menu Configuration

PBI DCH-5000P
- 8 -
LNB 22KHz: activate the LNB 22 kHz control signal to the LNB: On or Off. <B>
DISQEC: Can select OFF/Port A/Port B/Port C/Port D
Note: please contact the local satellite operator for the satellite frequency and symbol rate.
<A> Normally, 13V switches the LNB to receive Vertical/Left hand polarization
while 18V receive Horizontal/Right hand.
<B> Normally, 22KHz control signal switches the LNB to receive high band if any.
5.1.3 Ethernet Menu
(The Ethernet menu is showed only if the IP streaming in/out board is installed and the
TS/IP streaming board is set to “IP IN”. Refer to section 5.2.7.)
The Ethernet connector is for receiving transport stream over IP. The Ethernet
connector has user-configurable IP address, network mask and default gateway. These
must be set to appropriate values for the network over which the transport stream over IP is
received.
Stream IP Addr: Enter the IP address for streaming IP input of the unit.
Stream Netmask: Enter the network sub mask for the subnet to which the unit is
connected for IP streaming traffic.
Stream Gateway: Set the gateway for the network to which the unit is connected
for IP streaming traffic.
Stream Mac Address: factory-set MAC addresses are guaranteed to be unique.
Therefore you cannot configure the address.
Multicast IP Addr: Enter the IP address of the multicast stream for the transport
stream over IP.
Multicase UDP Port: Enter the UDP port number of the TS over IP stream.
Protocol: select the protocol for multicast: UDP or RTP.
Output Smoothing: set the quality of TS which comes from the TS/IP input.
Auto: the bit rate is variable.
Disable: the unit let the TS pass by.
Fixed Rate: the bit rate is fixed.
TS Bit Rate: set the bit rate of the TS comes from the TS/IP input. The setting is
only valid when the output smoothing is configured as Fixed Rate.
5.2 Outputs Menu
Under Outputs Menu, you can monitor and configure the parameters of the CI, AV
decoder, ASI out, ASI2/SDI out, Mux (A), and TS over IP output (B).
Note: (A) The Mux menu is showed only if the functional block is enabled. Refer to section