PBI DCH-5000P - Decoder Settings

PBI DCH-5000P
- 10 -
Slot 2 (de-encrypted with lower CAM inserted)
Bypass (no de-encryption).
The status will be shown in the first row on the LCD display. Confirm this setup when
leaving this sub menu, press <ENTER>-key to save or press <EXIT>-key to scrap.
The de-encrypted program could be delivered to other functional blocks, like A/V
decoder, ASI1, ASI2, SDI, Mux and TS/IP output (refer to section 5.2.3~5.2.8 for
more).
5.2.3 Decoder
You can configure the parameters of Video and Audio of the program decoded by AV
decoder.
Source: Press the <ENTER>-key and use the <
> or < >-key to roll up or down to
select the signal source of ASI output, there are 5 type of signal source optional:
CI De-encrypted: the de-encrypted transport stream from CI functional block
will be delivered to the ASI output port on the back panel.
TUNER: the transport stream from Tuner block will be delivered to the ASI
output port on the back panel.
ASI1 Input: the transport stream comes from ASI1 input port will be delivered
to the ASI1 output port on the back panel.
ASI2 Input: the transport stream comes from ASI2 input port will be delivered
to the ASI2 output port on the back panel.
Mux TS: the transport stream comes from internal Mux functional block will be
delivered to the ASI output port on the back panel.
(The Mux TS is valid only when the Mux function block is enabled and turned
on. The Mux TS indicates not only the after-multiplexed TS when Mux is
enabled, refer to section 5.2.7 and section 5.3.6 for how to set the Mux
function block.)
Press <ENTER>-key to save or press <EXIT>-key to scrap. A few seconds after the
source being selected, the TS will be delivered to the ASI output port on the back
panel.
Program: under this sub menu, you will see all program names detected by
DCH-5000P. The programs could be coming from ASI input, Tuner, TS/IP input or the
internal CI de-encryption block. Use the <
> or < >-key to roll up or down between
the program names, and use <
>-and < >-key to switch among input sources, where
a number in front of the program name indicates the input source:
A-xxxxx displays the program name, which comes from ASI input.
T-xxxxx displays the program name, which comes from TUNER input.
I -xxxxx displays the program name, which comes from TS/IP input