PBI DCH-5000P - Ethernet Output Settings

PBI DCH-5000P
- 13 -
On ‘Mux List’ sub-menu, on the first row, all encrypted programs are labeled with a ‘$’
sign. All programs that are being selected to be re-multiplexed are labeled as ‘Pass’,
otherwise, the un-selected programs are labeled as ‘Fobrid’. Use <ENTER>-key to
selected or un-selected the program being shown.
When leaving the ‘Mux List’ sub-menu, a new menu will be shown ‘Confirm changed?’
Press <ENTER>-key to validate all programs just be selected to be multiplexed or to
scrap by pressing <EXIT>-key.
After a few seconds, the multiplexed TS will be generated and delivered to the
specified destination(s).
5.2.7 Ethernet
(Note this menu is showed only when the TS/IP streaming is installed and the board is
set to “IP Out”, refer to section 5.3.6 for how to set up.)
The TS/IP Ethernet connector could also be configured as the output of the transport
stream over IP. The parameters listed below must be set to appropriate values for the
network over which the transport stream over IP is broadcasted.
Stream IP Addr: Enter the IP address for streaming IP output of the unit.
Stream Netmask: Enter the network sub mask for the subnet to which the unit is
connected for IP streaming traffic.
Stream Gateway: Set the gateway for the network to which the unit is connected for IP
streaming traffic.
Stream Mac Address: factory-set MAC addresses are guaranteed to unique. Therefore
you cannot configure the address.
Protocol: select the protocol for multicast: UDP or RTP.
TS Pkts Per UDP: set the number of the TS packages encapsulated in one UDP
package. The valid range goes from 1 to 7.
Time To Live: set the number of the routers over which the TS over IP can be
transmitted. The valid range goes from 1 to 5.
Type of Service: select the type of service. There are: Normal, Min Monetary Cost, Max
Reliability, Max Throughput or Min Delay.
Source: select the source of the transport stream over IP streaming output. There are 5
type of source optional:
ASI1 Input
ASI2 Input
CI De-encrypted
TUNER
Mux TS (note the Mux TS is showed only when the Mux function block is
enabled and turned on. The Mux TS indicates not only the after-multiplexed TS