PBI DCH-5000P
- 14 -
when Mux is enabled, refer to section 5.2.7 and section 5.3.6 for how to set the
Mux function block)
BISS De-encrypted
After the operation, the selected transport stream will be delivered to the TS / IP
function block for further operation.
Mode: select the mode of IP stream, you can select DVB or IPTV.
DVB mode: the transport stream which comes from the ‘source’ selected in
previous step will be packed into IP Stream directly. Therefore the IP stream
carries all programs and be delivered to the specified Multicast or Unicast IP
address.
IPTV mode: the transport stream which comes from the ‘source’ selected in
previous step will be de-Muxed to several single programs, and each program
is packed into one IP stream. Therefore each IP stream carries only one
program and be delivered to the specified Multicast or Unicast IP address. You
can configure maximum 6 IPTV channels.
Uni/Multicast Setup: use <ENTER>-key to enter sub-menu. The sub-menu is different
according to different ‘mode’ selected in previous step.
DVB mode
Multicast IP: Enter the IP address of the IP stream for the transport stream over IP
output. You can configure the IP stream output mode in Multicast or Unicast.
Multicast could be established by setting Multicast IP address in the range of
239.255.255.255 to 224.0.0.0.
Unicast could be established with the same settings of Multicast, the only
differences are the Multicast IP address, and should NOT be in the range of
224.0.0.0 to 239.255.255.255, which is for Multicast. Although the display is
'Multicast IP' on the first row, the stream itself is Unicast. The IP address of
receiver device (maybe PC with VLC) needed to be set to as the unicast
address on DCH-5000P, please don't use DHCP to get a dynamic IP address
for receiver device.
Multicast UDP Port: Enter the UDP port number of the TS over IP stream output.
IPTV mode
Max Channels (<=6): you can configure the number of IPTV channel. The valid range
goes from 0 to 6.
After the configuration, you can use <
> < >-keys to roll up and down between the
channels. Each channel could be configured independently.
Channel x: ‘x’ means the channel number. Press <ENTER>-key to go down to the
To Next Page
Loading...