PBI DCH-5000P
- 15 -
sub-menu. There are 4 sub-menus:
x-Multicast IP: Enter the IP address of the IP stream for the transport stream
over IP output.
You can also configure the IP stream output mode in Multicast or Unicast by
setting Multicast IP address.
x-Multicast Port: Enter the UDP port number of the TS over IP stream output.
x-Switch: each channel could be switched On/Off independently. The default
value is ‘off’. To activate the channel, you should turn on.
x-Program: it shows all programs carried by the transport stream from the
source selected. Press <ENTER>-key and use <
> < >-keys to roll up and
down between the program names, where a number in front of the program
name indicates the input source:
A-xxxxx displays the program name, which signal source is ASI.
T-xxxxx displays the program name, which signal source is TUNER.
I-xxxxx displays the program name which comes from the internal CI
functional block.
C-xxxxx displays the program name which comes from the internal Mux
functional block.
All encrypted programs are labeled with a ‘$’ sign on the first row. Press
<ENTER>-key to the program just be selected to be delivered to the specified
IPTV channel or to scrap by pressing <EXIT>-key.
To Next Page
Loading...