Need help?Do you have a question about the PBI DCH-5000P and is the answer not in the manual?
Procedures for inspecting the device for damage and performing initial operational tests.
Shows the signal status for ASI1, ASI2, TUNER, and IP IN ports.
Sets QPSK parameters for DVB-S2 input, including LNB frequency and symbol rate.
Configures network settings for IP streaming input, including IP address and gateway.
Manages Biss Mode, Biss 1 Setup, and Biss E Setup for encrypted content.
Configures Common Interface settings for CAM modules and program de-encryption.
Procedures for inspecting the device for damage and performing initial operational tests.
Shows the signal status for ASI1, ASI2, TUNER, and IP IN ports.
Sets QPSK parameters for DVB-S2 input, including LNB frequency and symbol rate.
Configures network settings for IP streaming input, including IP address and gateway.
Manages Biss Mode, Biss 1 Setup, and Biss E Setup for encrypted content.
Configures Common Interface settings for CAM modules and program de-encryption.
To Next Page
General