PBI DCH-5000P - Optional Function; Machine Type

PBI DCH-5000P
- 17 -
All the user configurable parameters will be set to the factory default settings, including
IP address and the unit name.
5.3.6 Optional Function
There are two submenus:
External Board Type: Press <ENTER>-key to active the menu, use <
> < >-keys to
configure the TS/IP functional block as ‘IP In’ or ‘IP Out’ or ‘No Exist’, and the option is
exclusive. Press <ENTER>-key to confirm or to scrap by pressing <EXIT>-key.
After the operation, you need reboot the unit to valid the configuration.
IP In: the TS/IP port is configured as input, you can feed transport stream over
IP into the unit. The menu ‘Ethernet’ will be showed under the inputs menu.
IP Out: the TS/IP port is configured as output, you can set the transport stream
over IP output to the IP network. The menu ‘Ethernet’ will be showed under the
outputs menu.
No Exist: the TS/IP port is invalid. Therefore the menu ‘Ethernet’ will not be
showed anywhere.
Mux Function: Press <ENTER>-key to active the menu, use <
> < >-keys to
configure the Mux functional block as ‘Enable’ or ‘Disable’. Press <ENTER>-key to
confirm or to scrap by pressing <EXIT>-key.
5.3.7 Machine Type
This setting is reserved for factory-setting, and you are not allowed to access this
menu.