PCTEL, Inc. Page 10 of 42 Rev T
2. Overview and System
Requirements
This section describes the SeeGull IBflex
scanning receiver, including the applicable
system configuration and software
requirements.
2.1. General Description
The SeeGull IBflex is a tool for signal
strength and modulation measurement,
engineered for the rigors of mobile network
testing during planning, installation, and
maintenance of wireless networks.
2.2. Initial Inspection
Upon receipt of the scanning receiver,
inspect the shipping container and verify
that the contents are complete and match
the packing list. The IBflex scanning
receiver should look similar to the picture in
Figure 1. If the contents are incomplete or
the SeeGull IBflex scanning receiver
appears damaged, please call the Technical
Support line at (240) 460-8833.
Figure 1 - SeeGull IBflex Scanning Receiver
(without battery pack)
2.3. Options
Optional multi-technology measurements
available for the SeeGull IBflex are
described below. These options can be
installed at the time of purchase or later on
as a field-upgradeable option with the
exception of OP641, CDMA/EV-DO
Holdover Option. Please contact your
PCTEL sales or marketing representative
for pricing and delivery information.
Technologies Option
The following Technologies option are
available on the 08900-E and 08900L-E
base configuration:
To Next Page
Loading...
