VI. OPERATION INSTRUCTIONS
Please read the safety tips vehicle carefully before operating the lift
To lift vehicle
1. Keep clean of site near the lift;
2. Position lift arms to the lowest position;
3. To shorten lift arms;
4. Open lift arms;
5. Position vehicle between columns;
6. Move arms to the vehicle’s lifting point;
Note: The four lift arms must at the same time contact the vehicle’s lifting point
where manufacturers recommended
7. Push the button of the power unit to lift until the lift pads contact underside of
vehicle totally. Recheck to make sure vehicle is safe on the lift;
8. Continue to raise the lift slowly to the desired working height, ensuring the vehicle
is balance on the lift;
9. Push lowering handle of power unit to lower lift onto the nearest safety lock. The
vehicle is ready to repair.
To lower vehicle
1. Be sure clear of around and under the lift, only leaving operator in lift area;
2. Push button “UP” to raise the vehicle slightly, and then release the safety device,
lower vehicle by pushing lowering handle.
3. Open the arms and position them to the shortest length;
4. Drive the vehicle away
Note: In order to extend the service life of the cylinder and seal, the lift needs to be
raised to the highest position at least once a day.
To Next Page
Loading...
